Manual: Degree Mode
Degree mode is used whenever you wish to move by an absolute angle each time. The first screen will prompt for the number of degrees to use for each move.
Enter the number of degrees as 5 digits (you can’t change the decimal point), e.g. for 75.50 degrees press 0, 7, 5, 5, 0.
Press [G] to continue or [C] to return to the main menu.
This is the main screen for degree mode. The screen shows mode (Degree), speed, current position in degrees and the initial angle setting.
Bottom line is machine status.
When first entering the position is reset to 0.00 degrees.
[<<], [>>] Indexes (moves) table CCW / CW by Deg.
[Speed] Cycles through the five table speeds. (Table must be stopped).
[C] Returns to the main menu. (Or stops table if moving).
[S] Emergency stop – table stops immediately.
,  Jogs table by 0.01 degrees CCW / CW. Effect is temporary and is lost when table is indexed.
,  Jogs table by 0.1 degrees CCW / CW. Effect is temporary.
,  Jogs table by 1.0 degrees CCW / CW. Effect is temporary.
[G] Allows Pos to be directly edited. Table will go directly to this angle. Once entered you’ll be asked for the direction, use [<<] or [>>] to rotate CCW or CW. Or press [G] to automatically take the shortest route. [C] will cancel at any point.
 Query and reset indicated position to 0.00.