Manual: Division Mode
Division mode is used to divide a circle into a set number of parts. The first screen will prompt you for the number of divisions.
Enter the number of divisions you want to divide the circle into as four digits. E.g. 0, 1, 3, 3 to divide into 133 parts.
Press [G] to continue or [C] to return to main menu.
This is the main screen division takes place on, it shows mode (Division), speed, current position in degrees and current division out of total divisions.
Bottom line shows machine status.
When first entering the position is reset to 0.00 degrees.
[<<],[>>] Indexes (moves) table one division CCW / CW.
[Speed] Cycles through the five table speeds. (Table must be stopped).
[C] Returns to the main menu. (Or stops table if moving).
[S] Emergency stop – table stops immediately.
,  Jogs table by 0.01 degrees CCW / CW. Effect is temporary and is lost when table is indexed.
,  Jogs table by 0.1 degrees CCW / CW. Effect is temporary.
,  Jogs table by 1.0 degrees CCW / CW. Effect is temporary.
[G] Allows Div to be directly edited. Table will go directly to this division. Once entered you'll be asked for the direction, use [<<] or [>>] to rotate CCW or CW. Or press [G] to automatically take the shortest route. [C] will cancel at any point.
 Query and reset indicated position to 0.00.