Manual: Programming Mode
Programming mode allows a sophisticated sequence of events to take place. It also facilitates the communication with other equipment.
Programs are edited and run from RAM, they can be permanently saved and loaded into one of ten slots.
Note that if you only want the controller for basic division etc then you can completely ignore this section.
All programming functionality is available from here.
Press the number relating to the mode you wish to use.
1 = Run – run current program in RAM.
2 = Step – single step (debug) program.
3 = Edit – edit current program in RAM.
4 = New – clear RAM.
5 = Load – load stored program into RAM for run or edit.
6 = Save – save RAM to store for later use.