Manual: Program Run
Starts the current program in RAM running.
Whilst running the following screen is shown, information shown is mode (Run), speed and current position.
[S] Terminates the program immediately.
[C] Switches to Single Step mode on the next instruction.
Whilst running the program can pause – waiting on an event. The following events are described by their associated command:-
Wait Sense. Displays “Waiting for SENSE” on the bottom line and the program will wait for the SENSE line to cycle high then low.
Wait Operator. Displays “Press [G] When Ready” and wait for the operator to press the [G] key.
Wait Time. Displays “Wait Time: nn” (where nn is the number of remaining seconds) when time reaches 00 controller will continue automatically.
The program finishes normally when the End command is reached and displays “Program finished” and “--- Press [G] ---“ along with final table position.
If the user terminates the program with the [S] key the messages “User Terminated” and “--- Press [G] ---“ are displayed.